e-mail:
voice:
360.854.9559
fax:
866.783.1742
9
ACS 16.2 Installation and Operation Manual
INSTALLATION
Open Collector/Relay Mode DIP Switch
Switch 6 Function
OFF
Burst mode control.
ON
Follow / MUX mode.
Power-up Mode DIP Switch
Switch 7 Function
OFF
Last Source Selected
ON
Use the “Burst” mode serial command *0CPS to store the current
selected input/output configuration.
Remote / “PIP” (Triggers) Mode DIP Switch
Switch 8 Function
OFF
Remote Control
ON
“PIP”/Triggers enabled
Mounting
The ACS 16.2 is designed to be rack mounted in a standard 19” rack. It should be
mounted in an area that is accessible from the rear and preferably away from sources
of heat. We recommend that you bench test and become familiar with the operation
of the ACS 16.2 before permanently installing it.
Power Supply Connection
Insert the universal AC input, multi-voltage DC switching power supply’s 5-pin DIN
connector into the power receptacle on the rear panel of the ACS 16.2. When ready,
plug the power supply into the appropriate AC receptacle.
M
CAUTION! Only use
the power supply provided with this product.
CAUTION!
Installation of the ACS 16.2 in high RF environments should be per-
formed with care. Shielded cable is suggested for all control, audio inputs and out-
puts. All audio cable shields should be tied to the “G” terminal on each channel.
The station ground should be connected to the chassis ground screw (“Chs Gnd”)
located on the right side of the chassis as viewed from the rear. For lightning pro-
tection devices, check out www.polyphaser.com and www.itwlinx.com.
It is recommended that all cables connected to the ACS 16.2 be looped through fer-
rite cores to suppress RF. Surge protection with RF filtering such as the Tripp Lite
“ISOBAR 4” is also suggested for the power distribution. The use of an uninter-
ruptible power supply (UPS) is highly recommend to provide backup power in case
of power outages.
WEBSITE:
Visit our web site for
product updates and
additional information.
