LBO-H/DP-EAD-T User Manual
Link Bridge
TM
Fiber Optic HDMI/DisplayPort Transmitter
Broadata Technical Support, [email protected]
9
2.5 Audio Interface
The audio interface supports one stereo channel high fidelity
analog or digital transmission. Line-level audio signals or SPDIF
digital signals are connected to the LBO-H/DP-EAD-T unit. The
following steps illustrate the installation procedures for audio
devices.
To send audio signals, label and connect one stereo audio-jack
cable to the “AUDIO” connector of the line level or digital audio
source. On the LBO-H/DP-EAD-T unit, connect the other end of
the cables to the front panel stereo jack connector labeled
“AUDIO IN” (see Figure 2-2).
2.6 Serial Data Interface
To transmit RS232/ IR data connect data source to the terminal
block shown in Figure 2-2.
The LBO-H/DP-EAD-T transmits two channels of data signals.
Follow the procedures for installing data terminal devices.
1. Label and connect one serial data cable to the user’s RS-232
data port.
2. Connect the other end of this cable to the front panel data
terminal block connector on the LBO-H/DP-EAD-T per the pin
out shown in Figure 2-2.
