BroadAccess VOIP-MG-H7 Card - Installation Instructions
P/N 760-000596 Rev B
April 2006
Page 5
The uplink to the IP network is implemented using an optical Fast Ethernet uplink
cable, or using an electrical Ethernet 100/BaseT cable. The cable can be
connected either directly to the operator's IP network, or can be routed through the
system's IP-UL-x series card.
•
For more information about connecting the Electrical Ethernet cable, see
Connecting the Electrical Ethernet Uplink Cable on page 5.
•
For more information about connecting the optical uplink cable, see
Connecting the Optical Ethernet Uplink Cable on page 5.
Connecting the Electrical Ethernet Uplink Cable
1.
Connect one end of the Ethernet Uplink cable supplied with the card to the
middle (marked P2) Ethernet Uplink connector on the VoP-MG-ADP card
backplane adaptor installed on the cage backplane.
2.
Connect the other end of the cable to one of the following, depending on the
type of uplink used to the IP network:
directly to the operator’s IP network
to IP-UL-x series card backplane adaptor, P2 (middle) connector.
Connecting the Optical Ethernet Uplink Cable
1.
Insert each connector on the IP-ADP-OP-S card backplane adaptor's middle
fiber optic connectors (marked P2) as follows:
a.
Align the key on the male 100 FX SFP optical connector on the FO cable
with the slot on the female connector on the backplane adaptor.
b.
Push it in until it clicks.
2.
Connect the other end of the fiber optic cables to the operator’s IP network.
