i
Scope
This Installer's Manual is intended to be used as a guideline for the installation of Brivis Gas Fired Central Heaters. It
covers only the installation and commissioning of the heater and the allowable flue configurations. Although
minimum recommended return air grilles and allowable duct outlet quantities are specified, it does not cover the
actual ducting design required to suit the installation. This Installer's Manual is based on Australian Standards - for all
other applications, please refer to local codes and regulations.
Brivis heaters must be installed by qualified personnel.
Models covered in this manual are as follows:
Brivis Classic Heaters
Internal Models
2PWN15
2PWN20
2PWN20 XA
2PWN26
2PWN26 XA
Definitions
Shall
Indicates a mandatory requirement of this manual
Should
Indicates a recommended requirement of this manual
Any deviations from these instructions may, at the discretion of Brivis, void the warranty. As a result, the customer
and/or installer may be charged a fee for non-product warranty related call outs. Also, note that failure to comply
with these instructions may preclude Brivis from being able to service the unit.
Safety Warnings
Do not place articles on or against this appliance
Do not use or store flammable materials near this appliance
Do not spray aerosols in the vicinity of this appliance while it is in operation
Do not modify this appliance
Disclaimer
IMPORTANT NOTICE: This document is a guide only. Laws, regulations and industry standards can vary
between States and Territories. Accordingly, this guide must be read in conjunction with, and subject to, all
laws, regulations and industry standards applicable in the State or Territory in which the products are
installed. You must ensure that the installation of the products will comply with those laws, regulations and
standards, and that the products recommended to customers are fit for the purpose for which they are
intended.
External Models
BX315
BX320
BX326
Internal Models
DF320 XA
UF320 XA
UF326 XA
Note:
Brivis Classic Ducted Gas Heaters do not have on
-board Add-On
Cooling connections, refer to the
Add-On cooling section for more detail.
Note:
The BX320 and BX326 models can be installed for extra air (XA) applications with an upgrade in
base box size, and these are an optional accessory
!
Warning – Important note
