OPERATION
Baby Unit
Set the power ON-OFF switch to ON position to turn on the unit. The power on indicator
will light up steady red.
Place the unit about 1 m from the crib with the microphone facing towards the baby.
Adjust the microphone sensitivity using the sensitivity Up Down buttons and such that
the unit will be set to transmit whenever the microphone picks up a sound at your desirable
loudness level. The transmit indicator will blink every time these buttons are pressed, more
number of blinks mean the microphone is more sensitive to sound (maximum is 4 blinks and
minimum is 1 blink).
Press to increase and to reduce microphone sensitivity.
Once the unit is in transmit mode, the transmit indicator will light up red. The unit will return
to standby mode a few seconds after the microphone stops picking up any sound and the
transmit indicator will go off.
Since this baby monitor is equipped with out of range alert function, the baby unit will transmit
a signal to the parent unit at regular intervals even when the microphone does not pick up
any sound.
The night light can be set permanently ON by moving the power ON-OFF switch to
position.
The condition of the battery is shown by the power on/battery low indicator .When the
battery runs down, the battery low indicator will start flashing. Replace with new battery or
use the supplied switching power supply.
The temperature sensor senses the temperature of baby’s room and send a signal to the
parent unit. For correct reading, do not block the ventilation of this sensor.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
8.
Parent unit
Set the power ON-OFF switch to ON position to turn on the unit. The power on indicator
will light up steady red.
Place the parent unit at a reasonable distance away from the baby unit to avoid feedback. Too
close a distance will create a screeching sound at the speaker .
Once the unit receives a signal, the LEDs in the level meter will light up. The louder the
baby’s voice, the more number of LED will be lighted up. This feature is useful in case the
parents prefer to turn down the speaker volume to keep the environment quiet.
The speaker volume can be adjusted using the volume Up/Down button & . Each press
of these buttons will create a beep sound and to will light up correspondingly in the
temperature indicator . means the speaker is completely muted and means
maximum volume.
This unit is equipped with a vibration alert. Set the power ON/OFF switch to position,
the vibration indicator will light up. Once baby’s voice is received, the vibrator starts
functioning. This feature is useful when the parent is working under very noisy environment
(e.g. Vacuum cleaning). To save battery power, it is recommended not to use the vibration
alert frequently.
1.
2.
3.
4.
5.
If pairing is successful, the on the Temperature indicator and the Tx indicator
should stop flashing, at the same time, 2 beep sound will be heard from the parent unit.
Switch off both baby and parent units and then switch them on again, the baby monitor is now
ready for operation.
In case the baby and parent unit cannot communicate with each other, repeat steps 1 - 7
again.
20
4
9
5
5
8
8
1
11
15
19
20
22
13
14
15
18
16
4
9
9
8
5
5
2
3
8
Summary of Contents for BC-50
Page 2: ......
