When the ring gear and lever are held
together you will see how they need to go
together.
There is only one possible way so you
can’t get it wrong!
Keeping the two rings together, it is time
to return them to there position on the
end of the winch itself.
You can choose your preferred location
for the lever as long as the ring gear is
also kept against the lever as shown
above.
You can see here that I have replaced the
main gear casing and started to tighten
the screws.
You may wish to just check that the label
is in a good place on the outside of the
case.
If not then turn the screws on to the next
tapped screw hole until you are happy.