BRITEQ®
21
BTX-300SW
7.2 Channel Mode Setting
Enter menu mode, select
DMX Functions
, press ENTER button to confirm, use UP and
DOWN button to select
DMX Channel Mode
, press ENTER button to confirm, present
channel mode will blinking on the display, use UP and DOWN button to select
Mode1 (22
channels mode)
or
Mode 2 (22 channels mode) or Mode 3 (29 channels mode)
, press
ENTER button to store. Press MENU button back to the last menu or idling let the unit idle
one minute to exit menu mode.
7.3 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 so that the units can receive DMX signal.
Press MENU button to enter menu mode, select
DMX Functions
, press ENTER button to
confirm, use UP and DOWN button to select
DMX Address
, press ENTER button to
confirm, the present address will blink on the display, use UP and DOWN button to adjust
the address from 0 to 512, press ENTER button to store. Press MENU button back to the
last menu or idling let the unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
22 channels
1
23
45
67
29 channels
1
30
59
88
BRITEQ®
22
BTX-300SW
7.4 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attention:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel
Function
, keep the value for about 5 seconds, then the corresponding
function will take into effect.
22 Channels mode 1:
