ENGLISH
OPERATION MANUAL
BRITEQ
®
3/20
BT-VMS3
FUNCTIONS
(FRONT)
1. POWER SWITCH:
used to switch the unit on/off.
2. VIDEO SWITCH:
used to send any of the 3 video inputs to the master output, just push the button!
3. VIDEO SCREEN:
3,5” color TFT-screen for preview of the connected video signal.
4. SCREEN SETUP:
5 buttons used to navigate the setup menu of the TFT-monitor. Things like brightness,
contrast, color, tint and menu language can be selected. You can also determine the image is shown
while no video signal is detected: blue screen or test screen with colored bars.
5. SOURCE SELECT:
you can connect a VGA and composite video signal (BNC/RCA) at the same time to
each of the 3 monitors. With the source select button you can choose which signal is shown on the
monitor. This signal will also be sent to the video switch (2) of the master output.
6. VGA RESOLUTION:
selects the resolution of the VGA output: 800x600 (SVGA) or 1024x768 (XGA).
7. SWIVEL BRACKETS:
these 19” brackets for rack mounting make it possible to tilt the unit in any
position for the best viewing angle.
Attention:
leave some space at the top and the bottom of the unit if
you want to use the swivel mechanism.
FUNCTIONS
(REAR)
8. COMPOSITE INPUT:
video input with BNC connector, RCA adapters are included for easy connection.
The video signal also be sent, through the video switch, to the master output
9. VGA INPUT:
supports VGA signals from for example PC in both 800x600 (SVGA) and 1024x768 (XGA).
The video signal also be sent, through the video switch, to the master output
10. COMPOSITE LOOP THROUGH:
output with possible video conversion, depending on the input used:
Composite IN (8) :
simple loop through of the composite video signal with monitoring possibility.
VGA input (9):
loop through with monitoring possibility AND video conversion: VGA to composite.
11. VGA LOOP THROUGH:
output with possible video conversion, depending on the input used:
Composite IN (8) :
loop through with monitoring possibility AND video conversion: composite to VGA.
VGA input (9):
simple loop through of the VGA video signal with monitoring possibility.
Note:
use the VGA Resolution selector (6) to set the resolution of the VGA output.
12. MASTER OUTPUT:
any of the 3 video inputs can also be sent to the master output using the
video
switch
(2). Both the composite (BNC) and VGA outputs carry the same signal and can be used
together, so in total you have 4 outputs.
13. REMOTE CONTROL:
this connection makes it possible to remotely control the unit. This function is not
ready yet, software will be available from our website when ready.
14. PAL / NTSC SWITCH:
used to set the unit in the desired video mode.
15. POWER INPUT:
use the supplied mains cable to connect the unit to the mains.
