Briteq BT-AKKUPOLE, Operation Manual, Page: 6 / 12

ENGLISH OPERATION MANUAL
BRITEQ
®
4/8 BT-AKKUPOLE
15. DISPLAY: show all information needed to operate the
projector easily. Below are the most common standard
messages:
A. Current operation mode
B. Selected DMX address (while in DMX mode)
C. Selected dimmer level (in %, while in manual mode)
D. Battery capacity left (in %)
E. Operating hours left (in hours)
PS1: calculated, based on the current light output.
PS2: shows 99,9hr while working on the mains.
16. BATTERY INDICATOR: gives instant information about the
battery status, without the need to wake up the display:
•
ORANGE: Battery is still charging
•
GREEN: Battery is fully charged
•
DARK: Battery in use, capacity left >20%
•
RED: Battery in use, capacity left between 20% & 10%.
•
RED blinking: Battery almost empty, capacity left <10%
→ charging is needed!
HOW TO OPERATE:
The setup menu of this projector was deliberately kept very simple to allow quick installation with less risk of
incorrect settings.
3 OPERATION MODESS
Press the
↑ and ENTER-buttons together for about 2s to select one of the 3 operation modes:
1. Wireless DMX-input + DMX-out ( DISPLAY = WDMX IN XLR OUT ):
The unit can be controlled by any W-DMX transmitter that is compatible with the
“Wireless Solution” W-
DMX™-protocol”. The received DMX-universe is also available on the DMX-output. This means that the
BT-AKKUPOLE can also be used as W-DMX receiver.
While in W-DMX-mode there are 3 possibilities:
A. WDMX NOT PAIRED: the display shows: WDMX NOT PAIRED
The projector is not ready to receive a W-DMX signal because it is not paired to a transmitter.
See
“PAIRING TO A W-DMX TRANSMITTER” to learn how to proceed.
B. PAIRED BUT NO W-DMX SIGNAL RECEIVED: the display shows: PAIRED NO WDMX
The projector is configured to receive a W-DMX signal but no signal is available.
A possible reason is that the projector is paired with a different W-DMX transmitter than the one
currently used. In this case you have to UNPAIR the projector and PAIR again with the transmitter.
See
“UNPAIRING FROM A W-DMX TRANSMITTER”
C. PAIRED AND WORKING: the display shows WDMX Ad:xxx (xxx = the actual DMX-address that
can be adapted, see below!)
PAIRING / UNPAIRING:
•
UNPAIRING FROM A W-DMX TRANSMITTER
Press the
↓ and ENTER-buttons together for about 2s and confirm with ENTER to start unpairing.
When unpairing is done the display shows WDMX NOT PAIRED and is ready to pair.
•
PAIRING TO A W-DMX TRANSMITTER
First check if the display shows WDMX NOT PAIRED.
If this is the case: simply press the
“PAIR button” on the W-DMX TRANSMITTER (!!!) → pairing is
done automatically, the display will show WDMX Ad:xxx (xxx = the actual DMX-address that can
be adapted, see below!)
SET THE DESIRED DMX-ADDRESS:
Just set different DMX-addresses if you want to set different dimmer levels on different projectors:
•
Press the ENTER-button for about 2s: the DMX-address starts blinking.
•
Press the
↑/↓-buttons to set the DMX-address and confirm with the ENTER-button.
Please note that the projector only uses 1 DMX-
address: DIMMER 0%→100% (DMX-value: 000→255)