ENGLISH
USER MANUAL
BRITEQ
®
5/9
BT-AKKUBAR
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Note: In the explanations below we assume that you will operate the projectors with the internal battery
which is already fully charged. If you want to use them with a mains cable, simply connect all projectors to
the mains using the supplied power cable and adaptor.
Electrical installation for 1 standalone unit:
•
Switch the projector on using the power switch (3). The unit starts working immediately in the last
selected stand-alone mode.
•
Refer to chapter [HOW TO SETUP] to learn how to switch between different working modes.
Electrical installation for one or more units in DMX-mode:
You can control the BT-AKKUBAR projector by wireless DMX.
The projector’s wireless DMX protocol is fully
compatible with
“Wireless Solution Sweden”.
WIRELESS SOLUTION
•
Switch the projector(s) on.
•
Set the desired DMX start address on the projector(s).
•
Switch on the wireless mode using switch (9).
•
Pair the projector(s) with the wireless DMX transmitter. (for example : JB Systems
®
“M-DMX
TRANSCEIVER II
” is 100% compatible)
•
Once this is done everything should work.
