24
•
Ensure the bit rate of audio from the source device can be supported
by BV-2322. Please refer to the details in Chapter 6
Audio Bit Rate
Support
.
No Supported Video
/Audio on WIDE mode
only.
•
Check the HDMI output setting of Source device, setup HDMI output
format to Auto mode instead of 1080p.
•
Check Chapter 5: “Supported Resolution”. Some resolution can’t be
supported on WIDE mode on.
IR Blaster can’t control
Source device.
•
Make sure IR Blaster sensor is close by or attached to source device’s
IR sensor. Please refer to Chapter 3’s Step3 for reference setup.
•
Change IR Blaster frequency to meet Source device’s requirement.
Please press Source key on top of the Receiver/Transmitter or RCU
to switch IR Blaster frequency 47K to 58K to 38K recurring.- The OSD
shows: (Display 5secs)
▃▆█
▃▆█
▃▆█
▃▆█
HDMI1 CH10 WIDE Off 1280x1024
IR Blaster Frequency [47KHz]
Press Source key again within 5seconds to change IR Blaster
frequency.
