8 of 11
Operation
The hood is operated by touch control.
Operation of the hood:
1.
Control TL
turns the lights on/off.
2.
Control T1
turns the hood on/off.
3.
Controls T2, T3 and T4
should be pressed to increase the speed of the motor.
Using the timer:
To enable the timer, keep one of the buttons T1, T2, T3 or T4 pressed down for a few seconds until it starts
blinking. The motor will continue to run for a set time and then switch off:
T1 - The hood will switch off after 5 minutes.
T2 - The hood will switch off after 10 minutes.
T3 - The hood will switch off after 15 minutes.
T4 - The hood will switch off after 20 minutes.
Cleaning and maintenance
Always turn off the electricity supply before conducting any cleaning or maintenance. After installation,
remove the protective film and clean the hood following the instructions below
.
Clean the glass with warm water and a small amount of washing up liquid in order to remove any grease.
Wipe the hood dry with a soft cloth to prevent water marks.
Use a reputable stainless steel cleaner for cleaning the stainless steel exterior of the hood and follow the
manufacturer's instructions.
The cooker hood must be cleaned frequently. Do not let dirt gather. Do not use acid or abrasive products.
Aluminium anti-grease filters
After 30 hours in operation, the leds of all speed buttons will switch on as a reminder to clean the anti-grease
filters. These can be cleaned by hand in hot soapy water or cleaned in a dishwasher. To reset the timer,
keep the the button T4 pressed for 2 seconds. If the timer is not reset, then all leds will switch on again after
the next time the hood is switched off.
Charcoal filters
After 120 hours in operations, the leds of all speed buttons will blink as a reminder to replace the charcoal
filters that are placed at the two ends of the motor. The charcoal filters can be replaced as follows:
1.
Remove the metal anti-grease filters.
2.
The charcoal filters can be taken off by turning the filters until they unfasten from the motor
(Picture 4 - G).
3.
Place the new charcoal filters at the two ends of the motor and fasten them (by turning them around).
To reset the timer, keep button T4 pressed for 2 seconds. If the timer is not reset, then all leds will switch on
again after the next time the hood is switched off.
Please note that there is no need to replace charcoal filters if the hood is ducted out. When all speed buttons
blink, you only need to reset the timer by pressing button T4 for 2 seconds.
4
.
With the button T4, select the maximum speed of the extraction fan for 5 minutes (button blinking), after
which the extraction fan will automatically switch to the 3rd speed.
Note: if you select the maximum speed, after 5 minutes the extraction fan switches to the 3rd speed and will
automatically turn off at such speed.
