Chuck Wagon Soft Cab
Enclosure
Notes:
•
Requires Brister’s folding windshield accessory (not included).
•
Soft cab can be used with or without ABS hard top.
•
Holes must be punched in soft cab to use hard top.
•
Doors will close on outside of hard top or the hard top can be trimmed to clear the
doors. (Brister’s recommends closing the doors on the outside of the top.)
Fastener package includes:
4-clamps
4-hinge clamps
8-7/16 nuts & bolts
A-back Bar
left and right doors
2-D bars
*** Remove ABS Hard top and windshield before installation***
1. Install clamps around middle of the upper rear bends of
cage, secure back bar (A) to clamps with 7/16 nuts and
bolts.
2. Assemble door by inserting middle bar (D) into one side
of door and tap with rubber mallet. To match up door
halves, the hinge pin should be on the outside of the rear
half while the long latch handle is on the inside of the front
half. Insert crimped ends into opposite side of door and tap
together. Repeat for second door.
3. Install door hinge clamps on rear cage bar next to top of seat and below bottom of seat.
Secure with 7/16 nuts & bolts. Insert hinge pin into hinge clamp (long handle will be on
inside of door.)