BRISTELL S-LSA, Maintenance And Inspection Procedures Manual

Page: 70 / 201

6. CHAPTER - CONTROLS
Document: SLSA-MIP-5-4-0-US Date of Issue: 05/2016 Revision: -
6-14
Tools needed:

wrench size 7/16 in

screwdriver

pliers
Bail arm attachment is shown on Fig. 6-12.
Remove the access hole cover on the bottom fuselage skin under the luggage
compartment (1).
Disconnect push rod ends (2) from the bail arm (3).
Disconnect bail arm lever (3) and lever hinge (4)
– remove the cotter pin, unscrew the
castle nut, put out the bolt.
Remove the bail arm lever (3).
Fig. 6-12
Two
–arm lever – front fuselage
1 - Cover on the bottom
skin
2 - Push rod end
3 - Bail arm lever 4 - Bail arm lever hinge
6.3.13 Installation of bail arm under the luggage compartment
Type of maintenance: heavy
Authorization to perform:
LSA mechanic or A&P mechanic (Airframe and Power plant)
Tools needed:

wrench size 7/16 in (11)

screwdriver

pliers
Attachment of the bail arm lever is shown in Fig. 6-12.