Introduction
Thank you for choosing Bristan, the UK’s leading taps and showers expert. We have designed this
product with your enjoyment in mind. To ensure that it works to it’s full potential, it needs to be
fitted correctly. These fitting instructions have been created to give you all of the information you
need and, if you need any further help, please do not hesitate to give us a call on 0330 026 6273.
Installation
1. Identify all components are present prior to installation.
2. Fit the waste body and one of the rubber washers (4) into the bath.
3. Place a second rubber washer (2) under the bath above the banjo (3), and secure using the
back nut (1) making sure the remaining washer (2) is between the backnut and the banjo.
Use a pure Silicon sealant to seal washer to prevent leaking.
4. Fit the overflow outlet parts (16, 15 & 14) to the bath using spacer (17) depending on the thickness
of the bath. Use a pure Silicon sealant where necessary.
5. Connect the overflow elbow (18) to the banjo fitting (3) using the flexible tube (13).
6. In order to fill the bath, the button in the middle of the waste needs to be pressed down. To
release water, press button again.
7. Check all joints and connections for leaks.
8. To clean the clicker mechanism (10), unscrew the caps (7&8) then unscrew the clicker mechanism
(10) from the base (6).
Components
1.
Back nut
x1
2. Rubber Washer
x2
3. Banjo
x1
4. Silicone Washer
x1
5. Waste Flange
x1
6. Mechanism Base
x1
7. Small Cap
x1
8. Big Cap
x1
9. Sealing Washer
x1
10. Clicker Mechanism
x1
11. O Ring
x1
12. O Ring
x1
13. Plastic Tube
x1
14. Overflow Cap
x1
15. Rubber Washer
x1
16. Foam Washer
x1
17. Plastic Washer
x1
18. Overflow Elbow
x1
Summary of Contents for W BATH05 C
Page 3: ...Notes...