Introduction
Thank you for choosing Bristan, the UK’s leading taps and showers expert. We have designed this
product with your enjoyment in mind. To ensure that it works to its full potential, it needs to be
fitted correctly. These fitting instructions have been created to give you all of the information you
need and, if you need any further help, please do not hesitate to give us a call on 0330 026 6273.
Installation
1.
2.
3.
Identify all components are present prior to installation.
Fit the pop-up waste. Bed in the waste flange (1) to the basin with a good quality clear silicon
sealant. This should compensate for any slight moulding imperfections that may be present
around the waste area.
Fit the large rubber seal (2) to the underside of the basin after applying silicone sealant to
both sealing surfaces, as shown in the diagram below. Secure by tightening the waste body
(3) onto the flange’s thread.
Remove any excess silicon sealant from the basin
4.
Place the pop-up knob & shroud assembly (10) onto the basin & secure using the small foam
washer (9), metal plate (8) & retaining nut (7) on the underside of the basin.
5.
Use pop-up link (5) to connect the vertical (6) & horizontal (4) connecting rods.
6.
Check all joints & connections for any leaks.
COMPONENTS
1.
2.
3.
4.
5.
6.
7.
8.
9.
Waste Flange
Large Rubber Seal
Waste Body
Horizontal Connecting Rod
Retaining Nut
Metal Plate
Small Foam Washer
Pop-up Knob & Shroud
Plug (Not Shown)
Summary of Contents for W BASIN13 C
Page 3: ...Notes...