Bidet Mixer
Bidet Mixer
Bidet Mixer
Bidet Mixer
1.
Identify all components are present prior to starting installation.
2.
Install mixer to the bidet, ensuring the washer (8) is fitted between the mixer body (7) and
the bidet.
3.
Screw the fixing rods (11) into the bottom of the mixer body (7)
4.
Slide the ‘C’ shaped rubber washer (9) and ‘C’ shaped metal washer (10) onto the fixing
studs (11) up to the underside of the bidet.
5.
To secure the mixer in place tighten the fixing nuts (12) onto the fixing rods (11) until they
are fully tightened against the ‘C’ shaped metal washer (10).
Note:
Note:
Note:
Note: The fixing nuts (12) can be tightened with a suitable
Spanner.
6.
Screw in the flexible connecting pipes (13) and tighten
by hand only (DO NOT OVERTIGHTEN).
hand only (DO NOT OVERTIGHTEN).
hand only (DO NOT OVERTIGHTEN).
hand only (DO NOT OVERTIGHTEN).
7.
Connect the hot and cold water supplies to the
flexible connecting pipes (13).
8.
Fit the waste (14) to the bidet, ensuring the shaped washer (15)
is fitted between the bidet and waste and the flat washer (16) is
1
2
3
4
5
is fitted between the bidet and waste and the flat washer (16) is
fitted below the bidet. It is advised that a pure silicon sealant is
applied to both sealing faces of the washers. The plug height
can be set by adjusting the waste rod (18), operating rod (20),
rod connector (19) and then screw in the base of the plug.
Note:
Note:
Note:
Note: Friction for the waste mechanism can be altered by the
adjustment screw (17). DO NOT OVERTIGHTEN.
9.
Turn on both water supplies, lift the
mixer handle (3) upwards and operate
in both directions, letting the water
flow for a few minutes to check
all joints and connections for
any leaks.
Note:
Note:
Note:
Note: The operating
rod (18) needs to be fed
from the underside of
the mixer.
6
7
8
9
10
11
12
13
18
10
14
15
16
17
20
19
www.divapor.com
