© BriskHeat
®
Corporation. Home of BriskHeat
®
Products. All rights reserved.
Drum / Pail Warmers
© BriskHeat
®
Corporation. Home of BriskHeat
®
Products. All rights reserved.
Drum / Pail Warmers
TABLE OF CONTENTS
INTRODUCTION
2
3
Thank you for purchasing a BriskHeat
®
drum /
pail warmer. Your warmer is designed to provide
a long and efficient service life with function,
reliability, and safety in mind. For additional
information or other BriskHeat
®
products, please
contact CDI at 800.777.2436
Introduction.................................................................
Safety Alert Symbol....................................................
Important Safety Instructions…..................................
Summary of Operation................................................
Prior to Installation......................................................
Installation of Warmer..................................................
Connecting Warmer to AC Power...............................
Operation of Warmer..................................................
Troubleshooting Guide………………...…...................
Warranty......................................................................
2
2
3
4
4
4
5
5
BACK
BACK
These symbols are used to call your
attention to instructions concerning
your personal safety. They point out
important safety precautions. They
mean “
ATTENTION! Become Alert!
Your Personal Safety is involved!
”
Read the message that follows and
be alert to the possibility of personal
injury or death.
SAFETY ALERT SYMBOL
Immediate hazards which WILL result
in severe personal injury or death
Hazards or unsafe practices which
COULD result in severe personal
injury or death
Hazards or unsafe practices which
COULD result in minor personal
injury or property damage.
IMPORTANT SAFETY INSTRUCTIONS
A person who has not read and understood all installation
instructions is not qualified to install this product.
•
Never handle the warmer while it is
in operation. Always disconnect the
warmer from the power source and
allow to cool prior to handling.
•
Inspect warmer before use.
•
Do not wrap the warmer over itself.
•
If spillage of foreign matter onto
warmer occurs, disconnect from
power source and clean after
warmer is allowed to cool.
•
Never operate a warmer without an
appropriate heat sink (device being
heated is considered a heat sink).
•
Fasten warmer to device using
approved methods only.
•
Do not repair damaged or faulty
warmers.
•
Do not crush or apply severe
physical stress on warmer or cord
assembly.
•
Disconnect warmer when not in
use.
•
Use specified sized warmer with
same sized drum. Do not use for
other applications.
Failure to observe these warnings may
result in personal injury or damage to the
warmer.
End-User Must Comply to the Following:
•
Only qualified personnel are allowed to connect
electrical wiring.
•
Disconnect all supply power at the source before
making any power connections.
•
All electrical wiring must follow local electrical
codes, it is highly recommended that NEC Article
427 is followed.
•
Final installation / wiring is to be inspected by the
authority who has jurisdiction in the area where
the warmer is installed.
•
The end-user is responsible for providing a
suitable disconnecting device.
•
The end-user is responsible for providing a
suitable electrical protection device. It is highly
recommended that a ground fault circuit breaker
is used.
Failure to observe these warnings may result in
personal injury or damage to the warmer.
•
Do not immerse warmer in liquid.
•
Keep volatile or combustible material away from
warmer when in use.
•
Use warmer only in approved locations.
•
Keep sharp metal objects away from warmer.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury.
Approval is valid only when
installed
in accordance with all applicable
instructions, codes, and regulations.
Agency Approvals
73/23/EC (Low Voltage Directive)
SAVE THESE
INSTRUCTIONS!
Additional copies of this
manual are available
upon request.
