BriskHeat
®
Corporation. All rights reserved
6
Hot Gun for Composite Curing
OPERATION OF HOT GUN
The heater must NOT be operated without some form of temperature control.
- Your heater is designed to operate at a specific voltage ±10%. Refer to the label on the
heater for proper operating voltage and wattage information. Failure to operate the heat-
er at the specified rating could result in overheating of the heating blanket, the surface
being heated, or personal injury. Also note lower-than-rated voltage will result in under-
heating.
- All electrical connections must be made by qualified personnel and in accordance with
all applicable codes and regulations.
1. Ensure heater is protected by a properly rated circuit breaker or fuse.
2. Use of a ground fault circuit interrupter (GFCI) is highly
recommended and may be required according to local electric code.
3. Plug TTQ3D-16 Controller into wall outlet.
4. Adjust the airflow dial on the back of the hot gun to 2.5 (Figure 5).
Firugre 5
Firugre 6
5. Open toggle switch on the back of TTQ3D-16 controller to activate hot gun
(Figure 6).
Note: Hot gun blows cold air initially.
6. Start curing program by pushing red power button on front of TTQ3D-16.
7. To shut down program, push red power button on front and close toggle
switch on back of TTQ3D-16.
