BEFORE FIRST USE
Your appliance has been packaged carefully to ensure the
product reaches you in good condition. If the product has been
damaged, dropped, has a malfunction in any way, or if the
supply cord is damaged, immediately contact your retailer for
replacement or repair.
Carefully unpack your appliance. Make sure you do not discard
any packaging material until all parts of the appliance have
been found.
Carefully wipe the exterior of the appliance to remove any dust
that may have accumulated. Dry with a dry towel. Do not use
harsh abrasive cleaners. Remove any label or sticker.
WARNING!
Do not immerse in water or any other liquids.
PACKAGE CONTENTS
You should have the following:
1 Vacuum cleaner
1 Floor nozzle
1 Flexible hose
2 Plastic extension tubes
OPERATION GUIDE
•
Carry the vacuum cleaner to the area to be vacuumed.
•
Fit the hose, extending tubes and floor tool to the vacuum
cleaner.
•
Extend or retract the brush on the main floor tool as
required for the type of floor to be vacuumed. Extend brush
for hard floors such as tiles or wood and retract for rugs
and carpet.
•
Ensure the dust compartment filter is correctly fitted.
Warning!
Do not operate without this filter assembly in
place.
2
•
Insert the power plug into a mains outlet corresponding
with the vacuum cleaner requirements of 220 – 240V ~ 50
Hz - AC only.
•
Switch on power at the mains outlet.
•
Set the suction control to the desired power level of the
vacuum cleaner. Rotate clockwise to increase and anti-
clockwise to decrease.
•
Depress the on/off switch to start or stop the vacuum
cleaner. The cleaner will now suction.
•
The vacuum cleaner has a manual air flow regulator
attached to the hose handle. This is used to briefly lower
the suction level during operation; the further open the
regulator the weaker the suction power.
•
Poor suction! If the suction is poor check the dust
compartment is not full. Regularly empty the dust
compartment. Never use without a filter assembly fitted.
CORD STORAGE
The vacuum cleaner is fitted with a cord storage system under
the base. Extend the rear cord holder assembly outwards and
carefully wrap the cord around this and the front wheel
assembly.
MAINTENANCE AND CLEANING
Vacuum
To clean the outer surface of the vacuum cleaner, use a soft
damp cloth and dry the appliance afterwards with a dry towel.
Ensure that no moisture enters the appliance. Stubborn spots
can be cleaned with a cloth moistened with mild liquid
detergent. Do not use solvents to clean plastic parts. Liquids
such as solvents, petrol and oils that contain chemical
substances may damage, corrode or destroy the plastic parts
of the appliance. Do not put any detergents or any cleaning
agents into the vacuum cleaner.
Keep the ventilation slots on the vacuum cleaner clean to
prevent the appliance from overheating.
3