3
ChickSafe Eco Door Opener installation and operating instructions:
Check that the door panels slide up
and down easily. They must slide
down under their own weight.
The panel with the grommet must
lift the other panel as it rises.
If the panels are tight make sure the
distance between the channels is
correct.
If the channels are not flat, fit
washers or similar packing behind
the channels at the fixings to correct
them.
D
A
A
2
Caution! - Please Note:
•
Use only alkaline AA batteries
•
Observe correct polarity to
prevent leakage or risk of fire
•
Do not mix old and new
batteries
•
Do not use re-chargeable
batteries
•
Do not use a 9 volt battery
•
Remove the batteries if you do
not intend to use the ChickSafe
Eco for a long period.
1
1/8”
(3mm)
Raise the sliding door to its fully
open position.
Support the door in that
position.
Once fitted, the ChickSafe will
always open the door to this
height. Make sure it is correct.
4 3/4”
121mm
Mark two hole positions
4 ¾”
(121mm) apart and approximately
6 ½” (
170mm) above the top of the
sliding door.
Make sure they are level and evenly
spaced above the centre of the door.
Make the holes with a
1/8” (
3.0mm)
drill bit or bradawl.
10
11
12
13
14
Fit the channels with the six black
wood screws (e).
Slide the door panel with grommet
down the channels.
It must be in the slot nearest to you
in each channel.
Slide the other door panel down the
channels.
It must be in the second slot in each
channel. The screws and nuts must
be at the front.
15
e
6 1/
2 “
170mm