2
Lock Button
Trigger
Switch
To Operate
Step 1:
Follow charging instructions below and allow battery to fully charge.
Step 2:
Depress trigger switch in handle to turn spotlight ON. Release trigger
switch to turn spotlight OFF.
Step 3:
To lock trigger switch to ON, depress trigger switch and push in lock
button on side of handle. To unlock and turn spotlight OFF, depress
trigger switch and release.
WARNING:
Never place spotlight face down when light is on. Doing so could
burn/ignite surfaces such as seats, carpeting, etc. and cause seri-
ous property damage. Always turn spotlight off when not in use.
•
A fully charged battery will provide approximately 20 minutes of
continuous light.
•
Do not allow battery to completely discharge. A dim light indicates a low
battery. Recharge battery as soon as possible after each use.
To Charge
Step 1:
Make sure the trigger switch is
NOT
locked ON.
Step 2:
Plug the AC or DC charger into back of spotlight. Charging is indicated
by illumination of the red L.E.D. light on left side of spotlight.
Step 3:
Allow battery to fully charge for at least 17 hours. Do not charge for
more than 32 hours.
Only use Brinkmann’s 6V 55W halogen bulb that is designed for this
rechargeable spotlight as a replacement. Use of any other bulb may result in
poor performance and may damage your spotlight.
IMPORTANT:
Do not touch the glass part of bulb with fingers as natural oils
affect the life and performance of bulb. Handle bulb by metal end
only.
Step 1:
Disconnect spotlight from power source.
Step 2:
Remove screws from right housing.
Step 3:
Holding the left housing secure, slowly lift the right housing off being
careful not to pull wire connections inside. Do not touch the inside of
reflector.
NOTE:
The glass lens is not attached to either housing. Use care
when disassembling to avoid breaking lens.
Step 4:
Push the wire retainer together and lift up as illustrated.
Step 5:
Pull bulb straight out from the reflector mounting plate.
Step 6:
Disconnect bulb wire from connector by holding the connector firmly
with fingers then pulling bulb wire straight out.
Step 7:
To install new bulb, grasp the bulb from the metal end (DO NOT
TOUCH THE GLASS PART) and insert into the reflector mounting
plate.
Step 8:
Replace wire retainer by pushing ends together so they catch on the
reflector mounting plate.
To Replace Bulb
