BRINKMANN PUMPS Bplogic, Operating Manual, Page: 92 / 291

5 Operating the pump controller
92 bplogic intelligent pump controller 18/02/2021

The parameters for the application modules are pre-
configured by the manufacturer.

Check that the parameters for the application modules are
correct before commissioning for the first time.

If there are problems with the configuration, contact customer
service:

When doing so, provide the current configuration file

Section 7.2.1
“Backup and restore
preparation
” on
page 249.
Or:

Have the pump controller’s order number and serial
number at hand.
 “Customer service”
on page 8
5.3.1 Checking the assignments to application modules
The application modules are created by the manufacturer according to the cus-
tomer’s specifications. The number of application modules and the corresponding
primary functions and secondary functions depend on the pump controller configu-
ration file that is used. Only the manufacturer can edit the configuration file. There-
fore, check whether all required application modules, primary functions and secon-
dary functions are present and assigned correctly before commissioning for the first
time.
1. In
“Configuration”
, tap
“Applications”
.
 “Configuration – Applications”
(Fig. 43) opens.

C
o
n
fi
g
u
ra
ti
o
n
_
a
p
p
lica
ti
o
n
s
-e
xce
rp
t-
0
1
.p
n
g
Fig. 43:
“Configuration – Applications”/”Configuration – Applications – Application
modules”