3
MANUAL CONTROL VERSION
The gas control is situated centrally under the
raised hearth. Piezo ignition is used to light the
pilot, which can also be lit with a match. The
pilot is designed to remain permanently on,
enabling the fire to be lit by simply turning the
gas control on.
TO LIGHT THE PILOT
With the gas control knob in the off position,
fully depress and turn the control knob anti-
clockwise to the pilot position (spark symbol)
until it clicks, check the pilot has lit (repeat if
the pilot does not light) and keep the control
knob pressed for at least ten seconds When the
control knob is released the pilot should remain
alight. If the pilot does not remain alight repeat
the procedure. If when established the pilot
extinguishes for any reason, the gas supply to
the fire will automatically be cut off by the flame
supervision device. Do not attempt to re-light
the pilot for at least two minutes.
TO LIGHT THE FIRE
With the pilot already lit as above, turn the gas
control knob anti-clockwise to the high setting
(large flame symbol).
TO REDUCE THE HEAT SETTING
Turn the gas control knob anti-clockwise
towards the low setting (small flame symbol).
TO TURN THE FIRE OFF
Depress the gas control knob slightly and turn
clockwise to the pilot position (spark symbol).
The main burner will go out and the pilot will
remain lit and may be left on permanently. To
turn the pilot off, depress the gas control knob
and turn clockwise to OFF.
REMOTE CONTROL VERSION
Please Note: The appliance buttons are an
optional extra and may not be available on your
appliance.
* (not available on LEDGE & STORM)
USER’S INSTRUCTIONS - ALL VERSIONS
A
High
position
Pilot
position
1
Manual control
Low position
Off position
On
Off
Stand-by
High
Low
3
2
Sensor
* Appliance buttons (4)
Pilot
Battery Connection
(Except LEDGE & STORM)
Remote control
