Briggs & Stratton Vanguard 10V300, Repair Manual

Page: 83 / 112

8
77
112
10. Route unterminated stop switch wire to valve cover
area.
Low Oil Sensor Module (If Equipped)
NOTE: If engine is equipped with electric start, do not
install low oil sensor module at this time. Low oil sensor
module is installed with starter motor/regulator.
1. See Figure 113. Install hex flange screw (
A ) to fasten
oil sensor module bracket to flywheel guard. Tighten
screw to 30-80 lb-in (3.4-9 N-m).
2. Connect one-place wire connector ( B ) between
armature and oil sensor module. Capture wire in
clip ( C ) on flywheel guard.
3. Connect one-place wire connector ( D ) between oil
sensor module and oil sensor.
113
Blower Housing
1. See Figure 114. Start four hex flange screws ( A ) to
fasten blower housing ( B ) to crankcase and engine
base. Exercise care to avoid pinching stator and/or
armature wires.
2. Using the sequence shown in inset, alternately
tighten screws to 80-110 lb-in (9-12.4 N-m). Verify
that bottom of blower housing is above or flush with
bottom of engine base.
NOTE: Use the internal T25 TORX recess for best
results.
NOTE: Top and bottom screws on cylinder head side
also capture cylinder heat shields. Bottom screw
to engine base on crankcase side also captures
flywheel guard.
NOTE: If engine is equipped with electric start, do not
install bottom screw on crankcase side at this time.
Bottom screw is installed with starter motor/regulator.
114
Rewind Starter
1. Inspect rewind starter as follows:
A. Pull rope to verify that pulley moves freely in both
directions.
B. Verify that tension increases when rope is pulled
and decreases when rope is released.
Not for
Reproduction