Briggs & Stratton R020833 Operator'S Manual Download Page 8

Not for 

Reproduction

Operation

How to Start Your Electric Pressure Washer

Follow the instructions below in the order presented. If 

you have any problems operating your electric pressure 

washer, please call the electric pressure washer helpline at 

(800) 743-4115

.

  1.  Place pressure washer near an outside water source 

capable of supplying water at a flow rate greater than 

3.0 gallons (11.4 l) per minute and no less than 20 PSI 

(1.3 BAR) at pressure washer end of garden hose. DO 

NOT siphon supply water.

  2.  Check that high pressure hose is tightly connected 

to spray gun and high pressure outlet. See 

Assembly

 

section.

  3.  Connect garden hose to water inlet.

NOTICE

   DO NOT run the pump without the water supply 

connected and turned on.

  •  Damage to equipment resulting from failure to follow 

this instruction will void warranty.

  4.  Turn ON water, point gun in a safe direction, press 

trigger lock button and squeeze trigger to purge pump 

system of air.

  5.  Install spray wand and selected nozzle onto spray 

gun. See 

Assembly

 section.

NOTICE

   The unit can be operated in vertical or horizontal 

positions.

  6.  Turn master ON/OFF switch (

A

) to OFF (0) position.

 7. Plug electrical power cord into a dedicated electrical 

circuit rated for 120 Volts AC at 15 Amps that is 

properly installed in accordance with all local codes 

and ordinances. Circuit is not to supply any other 

electrical needs. The indicator light on the GFCI 

should be ON.

NOTICE

   The indicator light must be ON for the electric 

pressure washer to operate.

  8.  Press TEST button (

B

). The indicator light (

C

) should 

be OFF.

  9.  Press RESET button (

D

). The indicator light (

C

should be ON.

NOTICE

   DO NOT use the electric pressure washer if 

above test fails.

 10.  Turn master ON/OFF switch to ON (I) position.

 11.  Point gun in a safe direction, press trigger lock button 

and squeeze trigger.

The electric pressure washer motor will start and stop as 

spray gun trigger is depressed and released.

The electric pressure washer is now ready for use. 

Instructions for use of the supplied accessories are given 

later in this section.

 

WARNING 

 Risk of electrocution. Use of an 

extension cord could cause electric shock or 

burn resulting in death or serious injury.

•  DO NOT use an extension cord with this electric 

pressure washer. Your home’s electrical circuit 

receptacle or extension cord may not provide lifesaving 

ground-fault circuit-interruption protection.

 

WARNING 

 Risk of electrocution. Non-operating 

ground fault circuit interrupter (GFCI) could 

result in death or bodily injury. If indicator light 

does not stay ON after test and reset, do not 

use GFCI.

 

WARNING

  Risk of eye injury. Spray could splash 

back or propel objects resulting in serious 

injury.

 

Always wear indirect vented (chemical 

splash) safety goggles marked to comply with 

ANSI Z87.1 when using or in vicinity of this equipment. 

NEVER substitute safety glasses or dry-condition 

goggles for indirect vented safety goggles.

A

B

D

C

Summary of Contents for R020833

















Reviews: