CleanShot™ 2050 PSI Pressure Washer
6
ASSEMBLY
IMPORTANT: Read entire owner’s manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
1.
Remove the parts bag, accessories, and inserts included
with pressure washer.
2.
Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3.
Remove pressure washer from carton.
Carton Contents
Items in the carton include:
•
Main Unit
•
Handle
•
High Pressure Hose
•
Spray Gun
•
Adjustable Nozzle Extension
•
Safety Goggles
•
Oil Bottle
•
Parts Bag (which includes the following):
•
Owner’s Manual
•
Engine Manual
•
Owner’s Registration Card
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolts (2)
•
“L” Hooks (2)
•
Plastic Knobs (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115. If calling for
assistance, please have the model, revision, and serial
number from the data tag available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1.
Fill out and send in registration card.
2.
Attach handle to main unit.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
5.
Connect high pressure hose to spray gun and pump.
6.
Connect water supply to pump.
7.
Attach nozzle extension to spray gun.
Attach Handle
1.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 1).
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit
(Figure 2).Tighten by hand.
3.
Insert one “L” hook through hole just above billboard
on left side of handle (viewing from rear of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten by hand.
4.
Insert other “L” hook through hole just above
billboard on right side of handle (viewing from rear of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten by hand.
Align Holes
Handle
Handle
Supports
Figure 1 — Attach Handle to Base
Figure 2 — Secure Handle
Hose Hook
Spray Gun Hook
Figure 3 — Attach “L” Hooks to Handle
