22
Wireless Monitor Operation
1. Remove battery access cover
A
on back of
monitor and install 2 AA batteries. (Observe correct
battery polarity which is embossed in the bottom of
the battery compartment). Replace battery access
cover.
2. The wireless monitor does not have an on/off
switch. When batteries are installed correctly, the
GENERATOR READY green LED light will flash
once every 10 seconds indicating the status of the
generator.
NOTICE
If communication does not begin upon placing
the generator in AUTO, installing batteries, and pressing
System Update, the monitor may need to be re-linked. To
link, follow Steps 3 through 6.
3. Locate the MENU AND ESCAPE buttons on the
control panel
B
. Press and hold for 3 seconds to
enter the linking mode.
4. “LINKING MODE” will scroll across the generator
control panel.
5. Locate and hold the SYSTEM UPDATE button
C
on the wireless monitor for 5 seconds. All 3 LEDs
will flash until the monitor links to the generator.
Once it links, the monitor will display the current
state. The monitor will try to link for 1 minute. (This
step can only be completed when the generator is
in Linking Mode).
6. Once the link has been confirmed, press the OK
button on the generator control panel to exit or the
control board will turn off linking after 5 minutes. The
generator will now communicate with the wireless
monitor.
NOTICE
It may take up to 1 minute for the monitor to
begin displaying the generator status correctly.
DEALER
NAME
DEALER
PHONE
generator power
service needed
generator ready
system update
1 low battery voltage
2 low fluid level
3 under/over voltage
4 engine does not start
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
# of flashes service needed
A
DEALER
NAME
DEALER
PHONE
generator power
service needed
generator ready
system update
generator systems
1 low battery voltage
2 low fluid level
3 under/over voltage
4 engine does not start
part #: 316196 fcc id: MCQ-XBS2C IC id: 1846A-XBS2C
5 low frequency
6 engine overspeed
7 high temperature
8 transfer switch
# of flashes service needed
C
MENU
ESC
AUTO
OFF
MANUAL
OK
B
B
Not
For
Reproduction