Not for
Reproduction
9
Step 2: Oil and Fuel
1. Move generator outdoors to a flat, level surface.
2. Turn dial and open cover over oil fill area.
3. Clean area around oil fill, remove oil fill cap/dipstick and
wipe with clean cloth. Replace dipstick. Remove and
check oil level.
NOTICE
Do not screw in dipstick when checking oil level.
4. Verify oil is at full mark on dipstick. Replace and
tighten oil fill cap/dipstick.
5. If needed, see
Maintenance
for instructions to add oil.
6. Replace cover over oil fill area.
Low Oil Indicator
The low oil indicator system is designed to prevent engine
damage caused by not enough engine oil. If engine oil level
drops below a preset level, the red LED low oil indicator light
comes on and an oil level switch will stop the engine. If engine
stops or the red LED low oil indicator light comes on when
you try to start the generator, check the engine oil level.
Fuel must meet these requirements:
• Clean, fresh, unleaded fuel with a minimum of 91 RON
(87 octane/87 AKI).
• Gasoline with an ethanol content up to 10% is acceptable.
E10
E15
NOTICE
Do not mix oil in fuel or modify engine to run on
alternate fuels. Use of unapproved fuels could damage
engine and will not be covered under warranty.
See
High Altitude
for 1524 m and above.
WARNING!
Fuel and its vapors are extremely
flammable which could cause burns or fire
resulting in death or serious injury.
• Do not refuel during operation.
• Do not smoke during refueling.
• Turn engine off and let it cool at least 2 minutes before
removing fuel cap.
• Fill fuel tank outdoors. Keep fuel away from sparks, open
flames, pilot lights, heat, and other ignition sources.
Check fuel lines, tank, cap and fittings frequently for
cracks or leaks. Replace if necessary.
7. Slowly remove fuel cap to relieve pressure in tank.
8. Slowly add unleaded fuel to red max fill indicator in fuel
tank. Be careful not to fill above the indicator. This allows
adequate space for fuel expansion.
9. Install fuel cap and let any spilled fuel evaporate
before starting engine.
High Altitude
At altitudes over 1524 m, a minimum 89 RON (85 octane/85
AKI) fuel is acceptable. To remain emissions compliant,
high altitude adjustment is required. Operation without this
adjustment will cause decreased performance, increased
fuel consumption, and increased emissions.
See an authorized Briggs & Stratton dealer for high altitude
adjustment information. Operation of the engine at altitudes below
762 m with the high altitude kit is not recommended.
Transporting
When transporting equipment, turn fuel valve to off ( )
position. Do not tip engine or equipment at an angle which
causes fuel to spill.
Operation
Max Fill Indicator
Oil Fill Cap/
Dipstick