Installation Guide for Hardwiring the Dash Cam
Hardwiring the dash cam directly to the vehicle power enables parking
surveillance feature of the device which is used to record any incident to the
vehicle while the ignition is turned off.
WARNING: Make sure you install the product only when the engine
ignition is turned off.
1. Connect the adapter tip end to the dash cam DC-IN power port and
connect the other end to the vehicle as follows:
Red (B+) to permanent 12V or 24V supply
Yellow (Acc) to a 12V or 24V supply which goes live when ignition is on
Black (GND) to Earth connection
2. From the location of the dash cam installation arrange the power cable
neatly so it does not interfere with vehcile controls or obscure the
driver's view.
Note: Arrange the wire so that cable does not interfere with the
vehicle airbag.
3. After connecting using the continuous power cable, turn the ignition to on
and wait up to 30 seconds to verify that the device automatically changes
to parking surveillance mode.
•
www.brigade-electronics.com provides various reference materials in
order to assist with interior infrared camera installation. Please visit the
Product Support Area of the website.
•
Brigade Electronics is not responsible for damages to the main unit and
/or any attached accessories due to improper user installations.
Brigade Electronics strongly recommends professional automotive
installation service to avoid such damages.
