Brigade Backsense BS-9000-WD, Installation And Operating Manual

Page: 14 / 42

14
3.9 Error States
If the display shows an error state
(see section “3.6 Display”) check for the following potential
issue below. If the error is resolved the display will return automatically after a few seconds
and the self-test to normal operation.
•
Sensor or extension cable not connected.
Action: Check all connectors are plugged together fully.
•
No data connection between sensor and display.
Action: Check for damage on connectors and cable.
•
No power connection to sensor.
Action: Check for damage on connectors and cable.
•
CAN communication error with sensor.
Cable is routed, or system is installed too close to an electric noise source in vehicle.
Action: Try to relocate affected part of the system.
User long press of
20 seconds and
release to unlock
buzzer
Detecting Mode (Buzzer beeping)
Non-detecting Mode (Buzzer not beeping)
Buzzer sounds for 2x 1 second
beeps at current volume level to
indicate entering unlocked state
(error mode beep paused)
User input not
received
User press
button within
10 seconds
Buzzer Locked
Buzzer sounds for 2x 1 second
beeps at current level to indicate
entering locked state (error mode
beep resumes)
Buzzer vol level
changes and
beeps for 2 secs
to demo new vol
level to user
10 second countdown begins.
Buzzer remains at current volume
level
User long press of
20 seconds and
release to unlock
buzzer
Buzzer sounds for 2x 1 second
beeps at current volume level to
indicate entering unlocked state
(detection beeping interrupted)
User input not
received
User press
button within
10 seconds
Buzzer Locked
Buzzer sounds for 2x 1 second
beeps at current level to indicate
entering locked state (detection
beeping interrupted)
Detection
beeping vol
level changes to
demo new level
to user
10 second countdown begins.
Buzzer remains at current volume
level