②
Put the spacers onto the expansion
screw bolts, tighten the nuts and fix
the bracket
5
)
Screw the adaptor into the bracket connector. Bind up the adaptor with thread seal tape and screw it onto the
bracket. Tighten the screws on the bracket and make sure the anti-off screws on the adaptor are loose. Hang
the camera safety hook onto the hanger of the adaptor.
6
)
Connect cables according to the tags on the wire. Check and sort out the cables and bind the connecting part
with insulating tape. Then pull the cables into the bracket.
7
)
Align
the
straight
side
of
D
-
shaped
head
to
the yellow sticker on the adaptor
,
then
push
the
camera
till
the
end
of the adaptor and rotate in pan by 180
°
until the yellow sticker on the adaptor aligns to that on the connector.
Tighten the 2 anti-off screws on the adaptor.
8
)
After finishing installation, double check to make sure the dome housing is tight. Peel off the films on the lens
and on the IR light glasses and then power on the device.
①
Bind thread seal
tape
②
Screw the adaptor into the
connector
③
Tighten screws at the connection
part of bracket
Anti-off screws
are loose
④
Hang the other side of
safety hook on the adaptor
9
4) Fix bracket. Make the
holes
on the bracket go through
the
expansion
screw
bolts
on
the
wall.
Put the spacers
onto the expansion screw bolts and tighten
the nuts.
①
Insert the expansion screw bolts
into the holes on the bracket and
get the base close to the wall
