Brewmatic 1034505, Parts And Service Manual

Page: 7 / 24

Page 7
TROUBLESHOOTING
Read and follow the cautions below before attempting to service this coffee brewer.
CAUTION:
Read and verify that the installation instructions have been followed before attempting to operate this appliance.
Incorrect installation or operating procedures will void the warranty and may damage this appliance.
Unplug the power cord before servicing, unless electrical testing is required. Be certain the power supply is of
the correct rating and polarity before connecting the power supply cord. The chassis must be grounded to
prevent possible electric shock. Failure to heed this warning may damage this appliance and may cause injury.
Under no circumstance should the hi-limit thermostat be by-passed. In the event of failure the hi-limit
thermostat should be replaced. Use only original or authorized replacement parts.
Carefully inspect the internal wiring for wear or damage when servicing. Worn or damaged wiring may cause
malfunctions and premature component failures. Replace any wires that have loose connections, damaged
insulation or show evidence of overheating. When repairing or replacing internal electrical wiring, in part or in
whole, use only terminals and wires with the same rating, gauge and insulation covering.
Adjusting the faucet flow beyond factory recommended settings could result in rapid cooling of the faucet flow or
result in excessive faucet head pressure.
Symptoms Solutions
1. The coffee brewer will not
operate. The lights and
warmers do not work, and the
coffee brewer will not brew
coffee.
Make sure the power supply cord is connected to a proper, working wall
receptacle.
Make sure the "Power" switch has been turned on.
Check the main circuit breaker in the building to see if it has tripped.
Reset or replace the hi-limit thermostat.
Check to make sure the internal wiring is correct. Inspect for loose,
damaged or overheating wires or terminals. Repair or replace wiring as
necessary.
Test the "Power" switch. Replace it if necessary.
Test the power supply cord. Replace it if necessary.