3
Adjust Turntable Height
This can sealer comes factory preset to work with the 500ml Standard Can in its Can Adaptor.
However, if for some reason the factory setting is not working properly, the Turntable height can
be adjusted up or down to get the perfect seam and seal on your cans.
How to adjust the Turntable
1.
Put the can in the Can Adaptor on the Turntable.
2.
Slowly, pull the Lever from its lower position to its upper position (see image below).
There should be a slight resistance when the Lever goes over the Ridge (see image below), and
the can should be firmly locked into place between the Can Adaptor and the Chuck. The can
should not be able to move up or down or back and forth. If the adjustment is too tight, the can
will begin to crack, and could get distorted when sealing.
If the there is a no resistance (too loose) or too much resistance (too tight) when pulling the
Lever over the Ridge, then the Turntable height needs adjustment, continue to point 3.
3.
To adjust, first loosen the Turntable Nut by using the included Brewly Turntable Nut Tool (see
image above). Hold the Lever in its position with one hand and insert the Tool into one of the
holes in the Turntable Nut and pull counterclockwise. Now the Turntable is free to be adjusted.
4.
To adjust the Turntable, use the fingers to rotate it either up or down. The adjustment is
correct right when the can cannot move anymore and is firmly locked in between the Can
Adaptor and Chuck.
5.
Lock the Turntable in its correct position by tightening the Turntable Nut using the Tool. Done!
Turntable
Turntable Nut
Ridge
Loosen
Turntable
Nut
(counter-
clockwise)
Tighten
Turntable
Nut
(clockwise)
Lever
Adjust Turntable Height
(use fingers)
Adjusting the Turntable Height
Brewly Turntable Nut Tool
