Breville BKE470 - V B10, Instructions Manual

Page: 6 / 12

6
Operating your Breville Moda Cordfree Kettle
Before first use
Remove any promotional material attached to your
kettle. It is recommended that before the first use,
the kettle is filled to the maximum level, boiled and
the water discarded. Your kettle will only operate
when positioned on the power base with the
ON/OFF switch in the ‘ON’ position. The kettle
will automatically switch ‘OFF’ once the water
has boiled.
Operation of your kettle
1. To fill the kettle,remove it from the power base
and open the lid by pressing the lid release
button. Fill with the desired amount of water. Do
not operate the kettle without water or fill above
the maximum mark on the water window. Too
little water will result in the kettle switching off
before the water has boiled.
2. Ensure the lid is closed and locked securely into
place. Position the kettle firmly onto the power
base. Insert the power plug into a 230/240V
power outlet and switch ‘ON’.
3. Press the ON/OFF switch to the ‘ON’ position.
The power ‘ON’ light will illuminate.
Never operate the kettle dry. Too little water will
result in the kettle switching “OFF” before the
water has boiled.Filling above the maximum mark
on the exterior of the kettle may result in boiling
water splashing from the kettle.
This kettle must only be used with the power
base supplied. Use caution when pouring water
from your kettle,as boiling water will scald. Do
not pour the water too quickly.
4. The kettle will automatically switch ‘OFF’ once
the water has boiled.Lift the kettle from the
power base and pour the water.Take care to
hold the kettle level,especially when filled to
the maximum level.To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
The kettle may be stored on its power base
when not in use.The power point should be
switched off and the appliance plug unplugged
from the power when not in use.
Safety boil dry protection
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water.If this occurs the
kettle will stop heating.Switch ‘OFF’ at the power
point and allow kettle to cool before refilling.When
the kettle has cooled down,the safety device can be
reset by removing and then replacing the kettle on
its base.
THIS APPLIANCE IS DESIGNED FOR THE BOILING OF DRINKING QUALITY WATER ONLY,
NEVER USE IT TO HEAT OR BOIL ANY OTHER LIQUIDS OR FOODSTUFFS. THE LID SHOULD
ALWAYS BE FIRMLY IN PLACE AND LOCKED CLOSED BEFORE USE.
DO NOT OPERATE THE KETTLE ON AN INCLINED SURFACE.
DO NOT MOVE KETTLE WHEN IT IS SWITCHED ON.