GB/IE
41
as described above by pressing and holding the
▼
button for
3 seconds and while the wave icon is blinking, press and hold
the
▼
button again for 3 seconds. The temperature indicator
will start to blink indicating that a new sensor is being searched
for and will be logged in.
VIEWING REMOTE (CHANNEL) TEMPERATURE
Select the TEMPERATURE window.
Static Display: Press the
CHANNEL
button to select measure-
ments from different remote sensors (channel 1, 2 or 3).
Channel Auto-Scan Display: To enable an automatic scan of all
present channels, press and hold
CHANNEL
, until the
icon is
displayed. The measurements from each remote channel will be
alternately displayed with a 5 seconds viewing.
NOTE:
the channel auto-scan feature can be activated only if there
are more than one remote sensors operating and are set to diffe-
rent channels.
PROGRAMMING TEMPERATURE IN CELSIUS OR FAHREN-
HEIT
Select the TEMPERATURE window.
Press and hold
MODE
button for 3 seconds to toggle the tempe-
rature unit in Celsius (ºC) or Fahrenheit (ºF).
TEMPERATURE ALARM
Select the TEMPERATURE window.
Press
ALARM
button selecting the desired alarm, the upper tem-
perature alert with
▲
▬
icon (if disabled, display shows
OFF
), or
lower temperature alert with
▲
▬
icon (if disabled, display shows
OFF
). Press and hold
ALARM
button until the temperature di-
gits fl ashing. Adjust the temperature digits using the
UP
(
▲
) or
DOWN
(
▼
). Press and hold either button for fast setting. Press
the
ALARM
to confi rm selection and return to the temperature
