22 / 28
12 Snooze function
1. When the alarm sounds press the SNOOZE/LIGHT touch sensor at the top of the device or the
SNOOZE/LIGHT button on the back to activate the snooze function. The alarm will sound again in
5 minutes.
2. Press any other button when the alarm sounds to interrupt the alarm until the alarm time will be
reached again.
3. The alarm will be turned off automatically if no button is pressed within 2 minutes.
4. The default interval of 5 minutes for the snooze function can be changed in the alarm setting
mode.
13 Receiving measurements automatically
Once the power supply is enabled, the base station will display the indoor temperature readings.
Readings from the remote sensor will be displayed within 3 minutes after powering it on.
If no signal is received, go ahead with the following steps:
Press and hold the UP button for 2 seconds to re-initialize RC signal receiving.
Read the detailed manual for more information about readings (see download information on page 2).
14 Manual measurement display
1. Press MAX/MIN button several times to display the stored values one after another.
2. Display order: Current values > MAX (highest values) > MIN (lowest values)
3. When displaying highest or lowest values, press and hold MAX/MIN button for approx. 3 seconds
to delete all saved values.
15 HI/LO Alert
HI/LO alert are used to alert you of certain weather conditions. Once activated, an alarm sound is
triggered and the alert icon flashes as soon as a set value is reached. Supported areas and alarm
types:
Area
Type of alert available
Indoor temperature
HI AL / LO AL
Indoor humidity
HI AL / LO AL
Outdoor temperature
HI AL / LO AL
Outdoor humidity
HI AL / LO AL
HI AL = High alert / LO AL = Low alert
HI/LO alert setting
1. First, select an area (channel 1, 2, 3 or Indoor). Press the UP button repeatedly until the arrow in-
dicator is at the desired position.
2. Press and hold ALARM button for approx. 3 seconds to enter the setting mode.
3. Press UP or DOWN button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Temperature HI AL > Temperature LO AL > Humidity HI AL > Humidity LO AL
Enable/Disable HI/LO Alert
1. First, select an area (channel 1, 2, 3 or Indoor). Press the UP button repeatedly until the arrow in-
dicator is at the desired position.
2. Press and hold ALARM button for approx. 3 seconds to enter the setting mode.
