Bresser MyTime Crystal P Colour, Instruction Manual

Page: 11 / 16

11 / 16
17 Projection onto walls or ceilings
1. Press SNOOZE/LIGHT key to start the projection of the current time for approx. 10 seconds. After
that the projection will be disabled automatically.
2. Turn the projector arm to the disred direction.
WARNING! Only turn the projector arm until it stops. Never overturn the projector arm! The
projector arm could be damaged!
The optimum projection distance should not be below 1.5 meters to a flat wall or ceiling surface in
a darkened room.
3. Turn the focus wheel to adjust the projection image sharpness.
18 Technical data
Main unit
Power supply: DC 5V 500 mA mains plug
Battery mode: 3x AAA type battery, 1.5V
Temperature measuring unit: °C / °F
Temperature display range: 0°C to 50°C (32°F to 122°F)
Humidity display range: RH 1% to 99%
Time format: 12 or 24 hours
Dimensions: 160 x 110 x 38 mm (B x H x T)
Weight: 460 g
Remote sensor
Batteries: 2x AAA, 1.5 V
Radio controlled signal: DCF
Transmission frequency: 433 MHz
Maximum radio frequency power: under 10mW
Temperature measuring unit: °C / °F
Temperature measuring range: -20°C to 50°C (-4°F to 122°F)
Transmission range: 30 m
19 EC Declaration of Conformity
Hereby, Bresser GmbH declares that the equipment type with part number: 7060100 is in compli-
ance with Directive: 2014/30/EU.The full text of the EU declaration of conformity is available at the
following internet address: http://www.bresser.de
20 Disposal
Sort packaging into different materials for disposal. Contact the local waste disposal service
provider or environmental agency for information about appropriate waste management.
Do not dispose of electrical devices with the household waste.
In accordance with European Directive 2002/96/EC regarding waste electrical and electronic
equipment and its incorporation into national law, used electrical devices must be collected
separately and recycled in an environmentally friendly manner.