DELIVERY CONTENT
LED Fresnel Light (A), remote control (B),
power adapter (C), power cable (D)
PARTS OVERVIEW
➊
LED Display
➋
Power switch
➌
Spot Setting
Adust the beam angle range of 20 - 80 degrees by turning the knob
➍
Dimmer knob
The knob provides dimmer control and remote channel selection.
Turn to adjust the brightness (10-99) or to select a channel (01-99)
Short press to get from brightness control to remote channel
select. Before use of remote, the controller must be paired with
the same channel.
➎
Power socket
➏
Locking screw (tilt joint)
➐
Fixing screw (tripod connection)
➑
Tripod connection
➒
Tilt joint
➓
Battery holder
⓫
Barn doors
⓬
Two-pin C7 socket
⓭
Barrel connector
⓮
Euro plug
⓯
Two-pin C7 plug
(B) Remote controller:
⓰
power button
⓱
- button
⓲
+ button
⓳
menu button
ESTABLISHING THE POWER SUPPLY
1. Insert the barrel connector (13) of the power adapter (C) into the
power connection socket (5) on the LED light.
2. Insert the two-pin C7 plug (15) of the power cable (D) into the
two-pin C7 socket (12) of the power adapter (C).
3. Insert the Euro plug (14) of the power cable (D) into a wall socket.
INSTALLING THE V-MOUNT BATTERY
(optional)
1. Slide the fully charged battery* (type NP-F970) into the holder (10)
from the side so that the battery clicks into place.
2. To remove, slide the battery out of the holder in the opposite
direction.
TURNING ON THE LED LIGHT
1. Establish the power supply for the device (insert battery or
connect power cable).
2.
Press the power switch (2) to switch the device on or off . The
lighting is switched on with the settings of the last use.
Important: Disconnect the device from the power supply if it is not
going to be used for a long period of time!
BRIGHTNESS ADJUSTMENT
1. Turn the dimmer knob (4) clockwise to increase the brightness.
2. Turn the dimmer knob (4) counterclockwise to decrease the
brightness.
➒
➑
➎
➌
➏
➐
➍
➊
➋
➓
⓫
⓬
⓭
⓮
⓯
⓰
⓲
⓱
⓳
*not included
A
B
C
D
