Bresser BR-20RGB, Instruction Manual

Page: 5 / 12

4 REMOVING THE BATTERY PACK
Press the battery release and then slide to take out the battery.
5 SPECIAL LIGHTING EFFECTS MODE
In the mode of bi color or RGB color selection, long press the M but-
ton to enter the mode of programmed special lighting effect. Anoth-
er long press of the M button will exit.
In the mode of special lighting, shortly press M button to switch
among different special lighting options.
Press the UP / DOWN button to increase or decrease the brightness;
Press the + or - button to adjust the flash frequency of the scenario
lighting.
F1: Paparazzi
F2: Fireworks
F3: Bad bulb
F4: Thunder flash
F5: TV
F6: Flicker
F7: RGB loop
F8: Police car
F9: Ambulance
F10: Fire engine
F11: Party
F12: Campfire
F13: SOS
6 EXTERNAL POWER SUPPLY
Use the original power adapter to extend the work time. When the
power adapter is used, the battery power supply will be cut off auto-
matically. Please note that the battery will not be charging when the
power adapter is in use.
7 INFRARED CONTROL
Control the power switch, dimmer, color temperature, color selection
and special lighting effects through the infrared remote control.
8 OPERATING AND USING
THE DEVICE
Slide the power switch as shown by the arrow to turn on the light.
ADJUSTING THE BRIGHTNESS
In the mode of bi color, press the UP or DOWN button to increase or
decrease the brightness.
ADJUSTING THE COLOR TEMPERATURE AND
SELECTING RGB COLORS
Press the M button to change between the mode of bi color and RGB
color selection.
In the mode of bi color, press the + or - button to adjust the color
temperature from 3000K to 6000K.
In the mode of RGB color, press + or - button to choose the option of
the saturation, dimmer and hue. When the selectedoption is flicker-
ing, press the UP or DOWN button to change the value.
DISPOSAL
Dispose of the packaging materials by type. Contact your local
waste-disposal service or environmental authority for informa-
tion on the proper disposal.
Do not dispose of electronic devices in the household garbage!
According to the European Directive 2002/96/EU on Waste Elec-
trical and Electronic Equipment and its transposition into na-
tional law, used electrical equipment must be collected separately
and recycled in an environmentally sound manner.
Observe the current legal regulations when disposing of the device!
Information on proper disposal can be obtained from municipal
waste disposal service providers or the Environmental Agency.
CLEANING
Before cleaning the device, disconnect it from the power supply (re-
move plug or remove batteries)!
Only use a dry cloth to clean the exterior of the device. To avoid dam-
aging the electronics, do not use any cleaning fluid.
Protect the device from dust and moisture. Store it in the supplied
bag or transportation packaging. The batteries should be removed
from the unit if it has not been used for a long time.
EC DECLARATION OF CONFORMITY
A "Declaration of conformity" in accordance with the applicable
directives and corresponding standards has been prepared by
Bresser GmbH. This can be viewed at any time upon request at
www.bresser.de/download/F004548/CE/F004548_CE.pdf
UKCA DECLARATION OF CONFORMITY
A "Declaration of conformity" in accordance with the applicable
directives and corresponding standards has been prepared by
Bresser GmbH. This can be viewed at any time upon request at
www.bresser.de/download/F004548/UKCA/F004548_UKCA.pdf
TECHNICAL DATA
Model 20RGB
Art. No. F004548
Type
LED light tube
LED illuminant 0.2 Watts High Bright SMD LEDs
99 daylight LEDs + 99 tungsten LEDs +
60 RGB LEDs
Max. Power 20W
2
Luminous flux 2400LM
Colour temperature 3000 - 6500K
Light dimming 10% to 100%
Power supply 8V 3A power adapter
4
Battery type
3
NP-F550/750/970
Dimensions 48x27x560 mm
1
The LEDs have a long lifetime and are not replaceable due to technical reasons.
2
The power of an LED lighting is higher than that of conventional halogen lights. Therefore,
LED's have a lower wattage than comparable lights.
3 Only use recommended accessories!
GUARANTEE
The regular warranty period is 5 years and begins on the day of pur-
chase. You can consult the full guarantee terms as well as informa -
tion on extending the guarantee period and details of our services at
www.bresser.de/warranty_terms.
www.bresser.de/warranty_terms