15 / 40
10. To deactivate the alarm, press the ALARM button when
the alarm time is selected until the corresponding alarm
symbol (alarm clock) is no longer displayed.
12 Snooze function
1.
Press the SNZ/LIGHT button for about 3 seconds to
enter the snooze time interval setting. The preset digit
flashes (03-20 minutes)
2.
Press the UP/CF or DOWN/RCC button to change the
value.
3.
Finally, press the SNZ/LIGHT button to save the set-
tings and exit settings mode.
4.
When the alarm sounds, press the SNZ/LIGHT button
to activate the snooze function. The alarm will sound
again at the end of the previously set time interval.
5.
When the alarm sounds, press any other button to stop
the alarm until the set alarm time is reached again.
13 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press the CH button for about 3 seconds to initate reception
of measurements again.
