25
TO VIEW MAX / MIN
In normal mode, press
[ MEM ]
key on the front side, to check records in below sequence:
Indoor or current CH MAX temperature Indoor or current CH MIN temperature Indoor or
current CH MAX humidity Indoor or current CH MIN humidity outdoor MAX temperature
outdoor MIN temperature outdoor MAX humidity outdoor MIN humidity MAX Feels like
temperature MIN Feels like temperature MAX heat index temperature MIN wind chill
temperature MAX dew point temperature MIN dew point temperature
MAX average wind
speed MAX gust wind MAX Beaufort
MAX relative baro pressure MIN relative baro
pressure MAX absolute baro pressure MIN absolute baro pressure MAX rain rate
MAX UV index, MAX light intensity. Then press
[ MEM ]
key for back to normal mode.
You can also, press another key to exit memory mode.
TO RESET THE MAX/MIN RECORDS
Press and hold
[ MEM ]
key for 2 seconds to reset the current on display record.
NOTE:
The LCD will also display the
/
icon, when showing the record(s).
6. CALIBRATION
The console is able to calibrate the weather readings:
1. In normal mode, press and hold
[ CAL ]
key for 2 seconds to enter the calibration mode as
below.
2. Press
[ CH / SET ]
key
to select different parameter as sequence: Indoor temperature
Indoor humidity CH temperature CH humidity outdoor temperature outdoor
humidity wind speed wind direction absolute baro pressure rain gain UV gain*
light intensity gain*.
Notice:
The gain method is used to calibrate the UV and light intensity offset. The value range
extends from 0.1 to 10. Appropriate reference values required for your location can be found
on the websites of the common weather services.
3. While the reading is blinking, press
[ W
I
ND / + ]
or
[ - ]
key to adjust the offset value.
4.
When finished, press
[ CH / SET ]
to proceed with next calibration by repeating process 2 - 3
above.
5. To return normal mode, press
[ CAL ]
key once.
BACK LIGHT
The main unit back light can be adjusted, using the
[ ON / AUTO ]
sliding switch to select the
Appropriate brightness:
-Slide to the
[ ON ]
position to set the back light to normal brightness.
-Slide to the
[ AUTO ]
position to set the back light brightness that according to ambient light level.
