Bresser 4007922062563, Instruction Manual

Page: 31 / 44

31 / 44
Searching for a sensor Reception symbol flashes
No signal for 48 hours 'Er' (Error) is shown
Sensor low battery status, good signal Battery symbol is shown
13 Time synchronization with the PC
Time and date are automatically synchronized for this unit when it is connected to a computer* using
the supplied USB cable. Proceed as follows:
1. Plug the microUSB plug of the USB cable into the USB socket on the device.
2. Plug the USB A plug of the USB cable into a free USB port on the computer.
3. Switch on the computer and wait about 5 seconds.
4. Start the 'WEATHER TOOL' software. This synchronizes the time.
5. Press the TIME SYNC button for about 8 seconds to deactivate or activate time synchronization.
6. Press the TIME SYNC button once to restart time synchronization.
NOTICE! The time synchronization is carried out via the software on the connected computer
with the time set there. Make sure that it is set correctly and that the software remains open un-
til the time has been synchronized. After successful synchronization, this is indicated by the syn-
chronization symbol in the display.
*Computer with Windows 7 or higher required.
NOTICE! If the device is connected to the computer via USB, it is supplied with power as soon as
the computer is switched on.
14 Manual time setting
To set the time / date manually, first disable the reception of the time signal by pressing the RCC but-
ton for approx. 8 seconds.
1. Press and hold CLOCK SET button for approx. 3 seconds to change to time setting mode.
2. Digits to be set are flashing.
3. Press GRAPH/UP or HISTORY/DOWN button to change the value.
4. Press CLOCK SET button to confirm and continue to the next setting.
5. Settings order: Hours > Minutes > Seconds > 12/24 Hour Mode > Year > Month > Day > M-D/D-M
Format → Sunrise/Sunset Longitude > Sunrise/Sunset Latitude > Sunrise/Sunset Time Zone >
Language (DST)
6. Finally press the CLOCK SET button to save the settings and exit the setting mode.
15 Alarm setting
1. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Hours > Minutes
6. Finally press the ALARM button to save the settings and exit the setting mode. Alarm will be activ-
ated automatically. The symbol will be displayed.
7. Press ALARM button in normal display mode to display the alarm time.
8. Press ALARM button during the alarm time display to disable the alarm.