13
JARO
Operating Instructions
D
INSTALLATION AND CONNECTION TO POWER SUPPLY 10 – 50 W
see figures p. 4,6 and 7
1. Before installation, always switch off the voltage supply .
2. Installation position: the floodlight should ideally be mounted using the wall bracket.
The floodlight must be installed at a height of less than 3 m
.
Recommended installation height for models with motion detector 2.5 m.
The floodlight can be angled up and down.
3. Remove the mounting bracket from the floodlight .
4. Mark the position of the drill holes for fastening the mounting bracket and drill
corresponding holes into the wall . Attach the bracket to the wall using suitable screws.
5. Open the plug connection .
6. Feed the connection cable through the plug sleeve, which has a seal .
7. Attach the floodlight to the mounting bracket.
8. Connect the strands of the connection cable to the luster terminal in the input connector in
accordance with (N = blue cable, earth symbol = green/yellow cable, L = brown cable).
9. Slide the cases over the input connector as shown in and tighten it. Take care to ensure
that both cases are sufficiently tightened – this ensures a sufficient seal.
10. Re-attach the mounting bracket to the floodlight.
11. Adjust the desired position of the floodlight and fasten the U bolts.
12. Switch the supply voltage back on .
INSTALLATION AND CONNECTION TO POWER SUPPLY 80/100 W
see figures p. 5
Mounting position: The spotlight should be ideally fixed with the wall bracket. It must be
installed at a height less than 3 m .
The light can be tilted by 90° downwards and by 45° upwards .
1. Always turn off the power supply before installation .
2. Unscrew the junction box on the back and loosen the pressure plate .
3. Insert the connection cable through the inlet pipe of the junction box and connect the
braids of the connection cable according to marking N and L .
4. Fasten the pressure plate and screw the junction box on .
5. Remove the retaining bracket from the spotlight .
6. Mark the position of boreholes for securing the retaining bracket and drill the respective
holes on the wall. Attach the bracket to the wall with suitable screws .
7. Secure the spotlight to the retaining bracket
.
8. Adjust the desired position of the spotlight and tighten the U-bolts
.
9. Turn the power supply back on .
18P083 LED Strahler Jaro PIR 180904.indd 13
04.09.2018 16:40:03
