Bremont JAGUAR MKI, Technical Notes

Page: 4 / 37

CHANGING THE STRAp
REmOvINg A STRAp
Use the end of your watch tool
to carefully lever the spring bar
out of the lug.
FITTINg A STRAp
Place one end of the spring bar
into the hole in the lug and use
the end of the watch tool to
lever the other end into position.
If you require a strap change it is strongly advised that you visit your
Authorised Dealer to avoid damage to the case.
BREMONT JAGUAR MKI
AUTOMATIC CHRONOMETER
Your Bremont watch shows you the time in hours, minutes and seconds,
and the date. The BWC/01-10 mechanical movement with automatic
winding has a free-swinging rotor that keeps the mainspring wound via
the motion of your wrist. The movement in your MKI has 25 jewels, runs
at 28,800 bph and has a 50+ hour power reserve once fully wound. The
watch is water resistant to 100m (10ATM) and the dial is protected by a
dual anti-reflective sapphire crystal that is retained securely in the case.
To ensure that this rather special watch continues to run beautifully for
years to come you must follow a few important operating instructions...
WINdING THE WATCH
Your watch has a screw-in crown. The purpose of the screw-in crown is
to protect the watch from penetrating water and to avoid unintentional
adjustment of the time or date. To unscrew the crown, rotate the crown
anti-clockwise where it will automatically assume position I. This position
is also the winding position for the watch, and you can manually wind
the watch by hand by rotating the crown clockwise. The movement will
automatically start with just a few revolutions of the rotor, however it is