
Page 2
_______________________________________________________________________________
Step 1 Setting up the first remote/channel
Tension motor
STOP until 2x
OK
Put tension on the motor, the product
Press and hold the
STOP
button until the
Transmitter/channel
moves up and down. The motor beeps.
product moves 2x up and down and beeps 3x. has been set.
______________________________________________________________________________
Step 2 Adjusting the direction of rotation(Only if the direction of rotation is not correct)
1x
▲
until 1x
▲
+
▼
until
1x
OK
Press 1x the
P1
button shortly,
Press
UP
and
DOWN
button
The direction of rotation
until the product moves down.
simultaneously, until the product moves.
of
the
motor is
OK.
_______________________________________________________________________________
Step 3 Adjusting endpositions of the motor
To determine where to stop the motor, use the adjustment pin provided.
The large arrow indicates the direction of rotation in which you change the end position.
By turning to the
Plus
or
Min
you can change the end position.
By turning to the
Plus
, the motor will make more revolutions.
By turning to the
Min
, the motor will make fewer revolutions.
The setting must be done for both directions of rotation.
If the motor has stopped on its own, do not turn more than 1 revolution towards the
Min.
If you turn more than 1 revolution to the
Min
, you can disable the adjustment.
______________________________________________________________________________
Additional settings
Option A Learn new transmitter/channel
= Already existing transmitter
= New transmitter
Method 1
P2 a until
P2 a until
STOP b until 2x
OK
Press
P2
of
a
. The product
Press
P2 of
a
. The product
Press
STOP of
b
. The product The transmitter
b
moves 1x up and down
moves 1x up and down
moves 2x up and down
has been added.
and beeps 1x.
and beeps 1x.
and beeps 3x.
Repeating the above will remove the new transmitter/channel.