Page 4
_______________________________________________________________________________
Step 5 Setting third limit position
If you press the stop button for more than 3 seconds, the motor will move from any position to the third limit position.
1x P2
2x STOP
Go to the desired
Press 1x the P2
Press stop
It moves momentarily.
third limit position
button.
button 2x.
for confirmation.
To remove the third limit position, you must go to the third position and repeat above action.
_______________________________________________________________________________
Additional settings
Option A Delete limit position
Deleting the limit position can be done in two ways:
1.
When setting up the first channel also the limit setup will be removed.
2.
1x P2
1x 1x P2
Each time you press a key you hear a beep.
The limit positions are now removed from the memory.
You can now re-read the limit position.
Press P2 button 1x.
Press the button down.
Press P2 button 1x.
_______________________________________________________________________________
Option B Teaching multiple transmitters
(Up to 20 transmitters per receiver)
2x P2
1x P2
Press P2 button 2x
Press P2 button 1x
Programming the new
of the existing transmitter.
of the new transmitter
transmitter is ready.
or channel.
To delete one channel , you must repeat the above operation.
_______________________________________________________________________________
Option C Reset all
1x P2
1x STOP
1x P2
Press P2 button 1x
Press stop button 1x
Press P2 button 1x
All channels are removed
_______________________________________________________________________________
Option D Pulse setting
1x
1x
1x
The motor is ready for use
Press P1 button 1x
Press up button 1x
Press down button 1x
To remove the pulse setting, repeat the above operation.
