b
x4
Tip:
If the seat
back is a little tight
going into the seat
base, partially
loosen 2 of the
seat screws to
allow the base legs
to open, insert the
seat back and then
re-tighten the
screws.
G
F
Tip:
When installing the chair bolts in Steps
6 & 7, insert the bolt into the hole, align it
with the nut and finger-tighten the bolt a
couple of turns into the nut before driving
with a drill. This will help to reduce the risk
of cross-threading.
e
x2
b
x1
a
x1
6.
Attach Part G to Part F
using 4 of hardware b.
8.
Assemble Part E into the chair. Insert
the tenon into the slot in one leg. Then
with slight pressure on the opposing leg,
push the opposite side of Part E into its
corresponding slot. Screw in place using 2
of hardware e.
7.
Turn the back/seat assembly on it's
side. Lay one arm/leg assembly from
steps 1-5 on the back/seat assembly
and bolt together using 1 each of
hardware a & b as shown. Flip the chair
to the opposite side and repeat.
4
AD-0100 Assembly
1-877-904-1234
www.Poly-Lumber-Furniture.com
