INSTALLATION
9
13.
Place the key (A) in the shaft end. Loosen the
setscrew (B) from the coupling half.
14.
Screw a threaded rod (E) into the shaft end.
Place the coupling half (C) on the shaft end.
Install a disc (D) and nut (F) on the threaded rod
(E). Turn the nut (F) to drive the coupling half
(C) onto the shaft.
15.
Fasten the setscrew (B) in the coupling half (C).
16.
At the front of the pumphead check if the shaft
in still correctly positioned in the flange. Place
the pump cover. Insert the washers and bolts.
Tighten the bolts in at least two crosswise
cycles. In the last cycle tighten them with the
correct torque. See section 6.3.
C
D
E
B
F
A
Summary of Contents for BREDEL PUMP Series
Page 2: ...Additional Information on Bredel 40 pump with bare shaft configuration Original Instructions...
Page 33: ...30...
Page 34: ...31...
Page 36: ...33...
