MAINTENANCE
40
6.
Place back the cover and fasten the retaining
bolts to the correct torque. Refer to §
7.
Switch on the electrical supply to the pump.
8.5.3
Fitting the pump hose
1.
Clean the (new) pump hose on the outside and
fully lubricate the outside with Bredel Genuine
Hose Lubricant.
2.
Fit the pump hose (A) via one of the ports.
3.
Run the motor so that the rotor pulls the hose
into the pump housing. Stop the motor when the
hose sticks out equally from both sides of the
pump housing.
4.
Check that the rubber compression rings (A)
are not deformed or damaged and replace them
if necessary.
5.
First fit the inlet port.
Fit the compression ring (A) in the bracket (B)
and lubricate both the ring (as shown) and the
hose end with Bredel Genuine Hose Lubricant.
Using lubricant enables a smooth assembly.
A
WARNING
During jogging the drive:
-
Do not stand in front of the pump
ports.
-
Do not try to guide the hose by
hand.
A
B
